| Premie HAL | User Guide | 9
Overall Warnings
Remember that damage caused by
misuse is not covered by your
warranty. It is critical to understand
and comply with the following
guidelines. Additional warnings are
found throughout the documentation
If the simulator will not be used for
an extended period, re-charge the
battery at least once every 60 days
to prevent damage.
Do not attempt to intubate without
lubricating the airway adjunct with a
silicone oil lubricant (provided).
Failure to do so will make intubation
very difficult and is likely to result in
damage.
NEVER disconnect the
communications module while the
UNI software is running. The
software will halt, and the module
may be damaged.
When simulating drug administration
via endotracheal tube, providers
must use an empty syringe. Passing
liquids into the trachea or esophagus
may cause internal damage.
Premie HAL should be cleaned with
a cloth dampened with diluted liquid
dishwashing soap. If medical
adhesives remain on the skin, clean
with alcohol wipes. DO NOT USE
“GOO GONE” as the citric acid in
the formula will cause pitting of the
various materials comprising your
simulator.
Store Premie HAL in a cool, dry
place. Extended storage above 85
degrees Fahrenheit (29 Celsius) will
cause the simulator to soften and
slowly warp. It is acceptable to
operate Premie HAL at an ambient
temperature of 95 degrees
Fahrenheit (35 Celsius).
Premie HAL is "splash-proof" but not
water-proof. Do not submerge or
allow a large volume of fluid to enter
the interior of the simulator. Do not
expose the tablet computer to water
or excessive dust unless it is
protected by a rugged case
(available separately).
Mouth to mouth resuscitation without
a barrier device is not
recommended, as it will contaminate
the airway. Treat Premie HAL with
the same precautions that would be
used with a real patient.
The use of needles larger than 22
gauge will reduce the lifetime of the
lower arms' skin and veins.
When the arm veins require
replacement, contact Gaumard to
arrange for a lower arm exchange.
Refer to the Consumables and
Replacement Parts section of this
guide, and contact customer service
for more information.
Do not inject fluids into the
intramuscular sites. Intramuscular
sites are for placement exercises
only.
Do not remove or replace the
umbilical cord while Premie HAL is
in operation. Doing so will cause
damage to the system.