The GemSignPdf.ini File
The GemSignPDF.ini is located by default in C:\Windows.
There are two sections in the GemSignPdf.ini. The first is [Justify].
•
JustifyX - This command sets a buffer in pixels from each side in the signature field. It
will create a zone at the edge of the field where the signature will be excluded.
•
JustifyY – This command sets a buffer in pixels from the top and bottom in the
signature field. It will create a zone at the edge of the field where the signature will be
excluded.
•
JustifyMode - This sets the justification, which is where the signature is going to be
displayed in the signature field. 0 is center, and 5 is justify and zoom signature (center
of control).
The second section is [GemSignPDF].
•
MinPoints - This sets the minimum points required to have a valid signature. If your
signature does not meet this minimum, the “Signature Capture” window will close when
you click “Accept”, but no signature will be embedded into the PDF.
•
PdfPenWidth - This sets the thickness of the ink displayed in the PDF in pixels. Modify
this in increments of 100.
•
SaveAs - When set to 0, Acrobat automatically saves after signing. When set to 1,
Acrobat prompts a “Save As” window after signing.
•
CompressionMode - Used to shrink the size (in data) of the signature being added to
the PDF. When set to 1, a lossless compression will be applied. When set to 2, a certain
percentage of signature points are removed from the signature. Use only 0 (for
uncompressed), 1, or 2.